Modificação externa
N1 - uma ranhura de fixação no anel externo
Folga radial interna
Lower Half of Normal Clearance
Precisão
Precisão P5 (maior que p6)
Estabilização térmica
Sem estabilização térmica - temperaturaa até 120 °C
Descrição do sufixo
TBIn The Case Of Bearings Of TB Design, The Axial Load Carrying Capacity Of Cylindrical Roller Bearings Was Significantly Improved With The Aid Of New Calculation And Manufacturing Methods. Optimum Contact Conditions Between The Roller And Rib Are Ensured By Means Of A Special Curvature Of The Roller End Faces. As A Result, The Axial Contact Pressures On The Rib Are Significantly Minimised And A Lubricant Film Capable Of Supporting Higher Loads Is Formed. Under Normal Operating Conditions, Wear And Fatigue At The Rib Contact Running And Roller End Faces Is Completely Eliminated. In Addition, Axial Frictional Torque Is Reduced By Up To 50%. The Bearing Temperature During Operation Is Therefore Significantly Lower
N1One Locating Slot (Notch) In One Outer Ring Side Face Or Housing Washer
BRBlack Finished, Factory-Applied Durotect® B Black-Oxide Coating. Durotect B Improves Run-In Behavior And Energy Efficiency While Reducing Surface-Induced Damage To The Bearing, Burnished Race
SP5Increased Accuracy (Partly P5)
CN/3L
CNNormal Radial Internal Clearance. +
/3LClearance Range Corresponding To The Lower Part Of 1/3 Of The Normal (CN) Clearance Range. Can Be Used As A Standard CN
Iniciar sessão
Bem-vindo, novamente! Pode iniciar sessão com a sua conta ABF.
